|
 |
|
|
 |
 Streaming Current Monitor Instruments
and Accessories |
|
|
|
Streaming Current
Monitor |
|
The
establishes a new level of control for plant operators that depend on
Streaming Current to maintain water quality. Unlike other systems, the
can be calibrated to a known Ion Charge unit (ICu) value, using a cationic
polymer solution. Once calibrated, the operator can use the
to determine the control set-point for the plant. This set-point is
established through optimization and it reflects the actual ICu of the
sample stream. |
STANDARD
FEATURES:
Graphical Display
Quickly view historical trending of ICu readings over an 8
or 24 hour period.
Calibration to a Known Value
Maintains accuracy over the life of the probe.
Built-in Diagnostics
Full time diagnostic software automatically monitors
and detects errors.
User Programmable Offset
Simplify human interface by setting the the output to reflect
zero when optimum dosing conditions are met.
On-Screen Instructions
Easy to use menus guide you through set-up and calibration
procedures.
Three Separate Alarm Contacts
System alarm and two user-programmable Hi/Lo ICu alarms provide
continuous confidence in the measuring process.
High / Low Gain Switch
Made in the USA
OPTIONAL FEATURES:
Flow Alarm
Automatically alerts operator if there is disruption in flow
to the sensor.
Proportional Integral Controller
Automatically controls coagulant dosing.
Serial Ports
The optional RS-232 or RS-485 serial ports allow the
to easily adapt into a digital environment. |
|
Establishing
an actual ICu value for the control set-point ensures the operator can
always return to the same conditions in the event of a plant upset,
equipment failure, or shut down. Routine calibration ensures that the
integrity of the output can be maintained by compensating for standard
wear-and-tear on the probe and electronics.
The graphical display of the
monitor provides the operator a fast and easy way to keep up with what is
going on inside the plant. Historical trending of readings over the previous
8 or 24-hour period is continuously displayed as a graph on the screen.
The sensor design incorporated into the
was developed to operate under the most turbid conditions. The HF
monitor, coupled with leading-edge sensor technology provides an easy-to-use
tool for precise control over your chemical dosing system. |
| SPECIFICATIONS
|
| Range:
|
±
10.00 ICu (SCU) |
| Resolution: |
0.01
ICu (SCU) |
| Accuracy:
|
±
1% of full scale |
| Response
Time: |
1
second |
| Alarms:
|
2
settable Hi/Lo/Off
1 System Alarm
1 Flow Alarm (requires optional hardware) |
| Average
Time: |
User
Selectable |
| Analog
Output: |
4-20
mA
0 to 10 VDC |
| Digital
Outputs: (Optional) |
RS-232
Serial
RS-485 Serial |
| Display:
|
Graphical
trending and numeric |
| Sensor
Probe: |
Submersible
to a depth of 120mm up to 6 to 10 liters per minute flow rate
required |
| Wetted
Materials: |
HPDE,
PTFE, Stainless Steel, Neoprene, ABS |
|
|
Streaming Current Instruments
and Accessories |
|
Operator's Manual
Full Specifications Sheets-screen
resolution
Full Specifications Sheets-printable version
Screen Resolution Literature and Specifications
Print Resolution Literature and Specifications |
|
|
|
Return to Products Page |
|
|
|
Home | About Us | What Is New? | Products | Contact Us | Exhibitions | Service | Downloads | Register |
